The retaining ring for shaft has overheating sensitivity and temper brittleness tendency during heat treatment

location:Home / NEWS / The retaining ring for shaft has overheating sensitivity and temper brittleness tendency during heat treatment

The retaining ring for shaft has overheating sensitivity and temper brittleness tendency during heat treatment

date:[2018-05-25]     pk_hits:
軸用擋圈的材料特性:它是用途較廣的碳素彈簧鋼,與65鋼相比,具有較高的強度、硬度、彈性和淬透性,臨界淬透直徑在水中一般為30~50mm,油中一般為16-32mm,熱處理時有過熱敏感性和回火脆性傾向,水淬時易開裂,一般采用油淬,截面尺寸>80的宜水淬油冷:退火后切削性尚好,但冷變形塑性低,焊接性能差。
擋圈(卡簧/卡環)

常規包裝以油紙或塑料為一個批次包裝,表面一般以磷化發黑為主,俗稱外卡。軸用擋圈生產時需要注意的幾方面;一是表面平整;二是硬度彈性合格;三是不能有邊角毛刺,國內目前廠家有質品五金,具備了擋圈成熟化工藝。
Rui'an Leichi Automotive Parts Co., Ltd

All product images and promotional images on this website belong to us and are not allowed to be used by any individual or organization. Misappropriation is subject to investigation.

Rui'an Leichi Automotive Parts Co., Ltd

Tel:0577-66003961Fax:0577-66003962Phone:13968888163 E-mail:8892@163.comAdd:zhejiang ruian pond town Lin industrial zone

WeChat

National Service Hotline

13968888163

We warmly welcome your consultation and will provide you with satisfactory solutions for automotive parts